Innokin T20S Kit

Innokin T20S Kit with 1500mAh battery

Main features:
Battery Capacity: 1500mAH Li-Po battery
Maximum Output Wattage：18W
Maximum Output Current：6A
Maximum Output Voltage: 3.85V
Clearomizer Resistance: 0.6 Ohm (min.)
Charging: Micro USB DC 5V/0.5A

How to charge
• Easy to charge via Micro 5pin USB port. When battery indicate that is full,

When Charging or Using the device:
The Endura T20 battery level status is displayed via green, yellow and red LED.
Green = Almost fully Charged.
When the Endura T20 battery is fully recharged the LED light will power off.
Yellow = about half Power.
Red = Low Power. Please Charge the Endura T20 battery .

How to fill the Innokin Clearomizer:
1. Unscrew the top.
2. Tilt clearomizer at 45 degree angle.
3. Insert needle tip and fill with e-liquid (avoid small metal hole)
4. Fill clearomizer to top fill line.
5. Screw top back on.

How to fit / exchange coil
1. Make sure the clearomizer is detached from the battery.
2. Turn the clearomizer upside-down, so that the mouthpiece is pointing towards the floor.
3. Unscrew the base of the clearomizer
4. Pull out the coil from the base and fit new. Make sure that coil sit properly in to the slot (a loose coil will cause the clearomizer to leak from airflow)
5. Screw the base back (if you see gap between tank and base cap it's mean coil was wronly fited)
6. Screw the clearomizer onto your battery.

Contents:
• 1x Endura T20S
• 1x Prism T20S Tank (0.8ohm)
• 1x Spare Prism S Coil (0.8ohm)
• 1x Spare Drip Tip
• 1x Quick Start Guide
• 1x Micro USB Charging Cable
• 1x User Packet

The warranty period for particular kit elements is: 
1 month from date of purchase:
• 1500 mAh battery 

The warranty does not cover Coils or Clearomizer, as these part are quickly used up while the products are put to normal use.

Tip - The batteries all come with a 5-Click ON/OFF feature. This can help prevent you from unintentionally turning the battery ON. Simply press the button 5 times in a row manually to turn the battery either ON or OFF. 

Sub ohm device. Worth reading before buying:
This type of device is intended for the user with grater knowledge and experience. Coils used are below 1.0 ohm so that higher Wattage could be used. Before you use please read manual. Often, this kits are equipped with additional options that allow you to adjust Wattage.

For Sub ohm devices we recommend that you do not use liquids with nicotine higher than 6mg / ml and only good quality liquids with 50/50 PG / VG or higher VG. Devices of this type produce a lot more of vape, which results in a stronger hit to the throat (like higher nicotine in the basic device). Ask if you're not sure ... we don't bite ;-)