Innokin T20S Clearomizer

Innokin T20S Clearomizer

Main features:
Coils: 1.5 Ohm 13W - 14W
Coil preintsaled: 0.8 Ohm 16W - 18W
Clearomizer capacity: 2 ml

How to fill the Innokin Clearomizer:
1. Unscrew the top.
2. Tilt clearomizer at 45 degree angle.
3. Insert needle tip and fill with e-liquid (avoid small metal hole)
4. Fill clearomizer to top fill line.
5. Screw top back on.

How to fit / exchange coil
1. Make sure the clearomizer is detached from the battery.
2. Turn the clearomizer upside-down, so that the mouthpiece is pointing towards the floor.
3. Unscrew the base of the clearomizer
4. Pull out the coil from the base and fit new. Make sure that coil sit properly in to the slot (a loose coil will cause the clearomizer to leak from airflow)
5. Screw the base back (if you see gap between tank and base cap it's mean coil was wronly fited)
6. Screw the clearomizer onto your battery.

Contents:
• 1x Prism T20S Tank (0.8ohm)
• 1x Spare Prism S Coil (1.5ohm)
• 1x Spare Drip Tip

The warranty does not cover Coils or Clearomizer, as these part are quickly used up while the products are put to normal use.